Silca Unocode 399 Plus - Page 26

Unocode 399 PLUS Operating manual - English
22 Copyright S ilca 2010
5) Enter the quantity of keys to be cut (max.999)
Fig. 24
6) Press ENTER.
Fig. 25
• Check that the clamp is the right one (e.g. V100 Side A)
• Install the key blank with the required reference (e.g. Stop 0).
• Check that the installed cutter is the right one (e.g. U01W - standard).
Cutters: some data cards available in the machine memory require the use of tools different from
the standard universal cutter U01W (e.g. key FO21P).
To replace the cutter follow the instructions given in chap.7.3, page 65.
number of pieces
a
b
c
d
e
F4
Accessory functions
(chap.5.3.2, page 25)
to cut
Press F4 to view all the functions
cutter to use
key stop: Stop 0
f
g
h
clamp to use
Accessory functions
(chap.5.3.2, page 25)