Silca Unocode 399 Plus - Page 31

Operating manual - English Unocode 399 PLUS
Copyright S ilca 2010 27
d) Data Card Parameters
Function used to view the tech nical data
relating to the data card.
•Press F4.
•Press F1.
• Press STOP to exit.
(*) With the measuring un it set on millimetres the hi ghlighted measure ments are e xpressed in
hundredths of a millimetre.
F1
F4
Key blank measurements *
Cutting angle
Symbols associated to cutting depths *
Cutting spaces *
Base of the cuts *
Key stop
Measuring unit