Unocode 399 PLUS Operating manual - English
48 Copyright S ilca 2010
Press START, the display will show:
Press ENTER to confirm, only if the previ ous
parameters were ON (***).
Press ST OP to cance l th e ope ration an d not
confirm the adjustments made (if there is one value
or more on OFF). The previous values remain valid
(already in the machine’s memory).
ATTENTION: if the STOP key is pressed, the new
settings will be lost. If so, only the previous setting
values will remain valid.
(**) If th e te mplates have no t be en prop erly
positioned the following ERROR message appears:
(***) If one or both the photocells or one or both the sensors are OFF, repeat the operation following
the procedure described in chap. 5.8.8, page 49.
To Next Page
Loading...
