●
Privacy patchs
Privacy patches can be used to obscure objects from view. Eight privacy patches can be configured and the state for each
patch is shown as either ‘Enabled’, ‘Disab’ or ‘Empty’.
Enabled patches are both defined and active - the camera will not be able to view them.
Disabled patches are defined but are currently inactive.
Empty patches are undefined.
When a patch is selected, you will see a status screen for that patch, as shown below.
Patch Status is used to select whether the patch is active or not.
Set at current pos configures the patch to obscure the current view. The view is calculated from the current pan, tilt and zoom
positions and it will be obscured immediately so you can verify if the privacy patch setting is correct.
Recall position moves the camera to the position used to define the privacy patch.
Clear patch disables the patch and clears the data from the camera memory.
●
●
To create a new privacy patch
Place the camera into the required pan/tilt/zoom position such that the area to be obscured lies well within the borders of the
video screen.
Enter the Setup menu, choose Privacy patches and then the required Patch number.
Choose the Set at current pos option.
Silent Sentinel Oculus
Version n.nnn (xxxx) xx
SN: FFFFFFFF POST: 000000000
Patch 1 Enabled
Patch 2 Enabled
Patch 3 Enabled
Patch 4 Enabled
Patch 5 Enabled
Patch 6 Enabled
Patch 7 Empty
Silent Sentinel Oculus
Version n.nnn (xxxx) xx
SN: FFFFFFFF POST: 000000000
Patch Status Empty
Set at current pos
Recall position
Clear patch
Exit menu
To Next Page
Loading...
