Mimic Tours
To create/replace a Mimic tour.
1 Position the camera to where you wish to start the tour.
2 Enter the Setup menu, choose Tours and then the required Mimic Tour number (M1 – M4).
3 Choose the Edit/record tour option. The tour will start to record immediately, displaying a count- down of the
available time.
4 Pan / Tilt / Zoom the camera as required for the tour pattern.
5 To end and store the recording, select Goto Preset 1 command.
6 To cancel the recording select the Menu function/ Goto Preset 2 command.
Video settings
This section deals with the default video feed at power on and allows the level and gain to be adjusted for the video outputs.
Video feed 0 selects the default video feed at power on (0 - optical or 1 – thermal (if applicable)).
Video level 0 allows you to adjust the signal amplitude for the optical camera feed, (Default 36).
Video gain 0 allows you to adjust the signal gain for the optical camera feed, (Default 128).
Video level 1 allows you to adjust the signal amplitude for the thermal camera feed, (Default 36).
Video gain 1 allows you to adjust the signal gain for the thermal camera feed, (Default 128)
.
Silent Sentinel Oculus
Version n.nnn (xxxx) xx
SN: FFFFFFFF POST: 000000000
Video feed 0 0
Video level 0 36
Video gain 0 128
Video level 1 36
Video gain 1 128
Alt video switch Off
Exit menu
To Next Page
Loading...
