Silex technology SD-300 - Dhcp Server Configuration

116
SD-300/SD-320AN User's Manual
IP Protocol Conguration
Name
Details
Each selection controls a TCP/IP based protocol.
Set "ON" for a protocol to allow a remote host to access the server using that
protocol. Set "OFF" to disallow use of the protocol.
Default All protocols ON
DHCP Server Conguration
Name DHCP Server
Details Enables/Disables the DHCP Server function (ON/OFF).
Default OFF
Name Start IP Address
Details Set the start IP Address for lease.
Default 0.0.0.0
Name End IP Address
Details Set the end IP Address for lease.
Default 0.0.0.0
Name Subnet Mask
Details
Set the subnet mask for IP address range.
If 0.0.0.0 (default value) is set, the subnet mask appropriate for the Start IP
Address will automatically be used.
Default 0.0.0.0
Name Default Gateway
Details
Set the gateway address.
This is disabled if 0.0.0.0 (default value) is set.
Default 0.0.0.0
Name Lease Time
Details
Set the lease time (Days/Hours/Minutes).
When the setting is "0Days 0Hours 0Minutes", assigned lease time is 10days.
Default 10Days 0Hours 0Minutes