Silex technology SD-300 - 3-1. What is Serial Device Server Setup?

26
SD-300/SD-320AN User's Manual
Command Details Note
SIGNATURE Exchanges the device information. Not supported
SET-BAUDRATE Changes the baud rate. Client -> Server (one-way)
SET-DATASIZE Change the bits per character. Client -> Server (one-way)
SET-PARITY Changes the parity. Client -> Server (one-way)
SET-STOPSIZE Changes the stop bit. Client -> Server (one-way)
SET-CONTROL
Enables/Disables the ow control or
use for PIN setting.
Client -> Server (one-way)
NOTIFY-LINESTATE
Server noties the client of line status
changes.
* Client -> Server (one-way)
NOTIFY-MODEMSTATE
Server noties the client of modem
status changes.
Client -> Server (one-way)
FLOWCONTROL-SUSPEND
The receiver of this command will be
unable to send any data or commands.
Client <-> Server (bidirectional)
FLOWCONTROL-RESUME
The receiver of this command will be
able to send data and commands.
Client <-> Server (bidirectional)
SET-LINESTATE-MASK
Set the information to send by NOTIFY-
LINESTATE.
Client -> Server (one-way)
SET-MODEMSTATE-MASK
Set the information to send by NOTIFY-
MODEMSTATE.
Client -> Server (one-way)
PURGE-DATA
Requests the server to clear the serial
buer.
Client -> Server (one-way)
SD-300/SD-320AN supports RFC2217. When SD-300/SD-320AN is used in Serial Port
Emulation Mode, you can utilize the following RFC2217 commands over the network.
RFC2217 Command List