Silex technology SD-300 - How to Use

5. How to Congure (SD-320AN)
63
5-5. Congure SD-320AN Using Smart Wireless Setup
This page explains the Smart Wireless Setup which can be used when your wireless router
supports WPS (Wi-Fi Protected Setup).
To perform the wireless conguration using WPS, you wireless router must support WPS.
Please make sure that a wireless router supporting WPS is set up in your environment.
To see if your wireless router supports WPS or not, refer to the operation manual that came
with the router or contact the manufacturer.
* Depending on your wireless router, WPS may need to be enabled manually. For details, refer to the
operation manual that came with your wireless router.
* If a security feature such as MAC Address ltering is enabled on your wireless router, disable it temporarily
so that SD-320AN can communicate with your wireless router.
TIP
Conrm that your wireless router supports WPS
Congure Network Settings
1.
Configure the TCP/IP settings and install the necessary application according to the
instructions from 1 to 10 at 5-4. Congure Network Settings.
* The wireless conguration at 8 will not be necessary. Click Next then.
Access the Web page of SD-320AN using the Web browser.
2.
* For details on how to access the Web page of SD-320AN using the Web browser, refer to Access the SD-
300/SD-320AN Web Page.
TIP
Note