Silhouette CAMEO5

04
Troubleshooting
70
Are the media you are using too thick?
• Change the media to those with good thickness supported by Silhouette CAMEO
5
.
Size of the media that can be cut:
Film : Thickness of
0
.
1
mm or less (excluding high-intensity reflective film)
Paper : Kent paper
157
g /m
2
, drawing paper*
1
, postcard*
1
, scrapbook paper*
1
, ink-jet font paper*
1
, Bazzill
paper*
1
, and cardboard up to
0
.
5
-mm thick *
1
*
1
: Some materials cannot be cut depending on the media.
The media are cut too much
Is the cutter blade sticking out too much, or is the force too high?
• In Silhouette Studio, set the blade depth and force to a smaller value and perform a test cut.
Force setting
Blade Depth setting
Test cut