Sim2 D10 - 2. SETUP AND OPERATION; Inserting Remote Control Batteries

D10
14
2. Setup and OperatiOn
Inserting the Remote Control Batteries
1.
Remove the battery compart-
ment cover by sliding the cover
in the direction of the arrow.
2.
Insert the supplied batteries tak-
ing note of the polarity (+/-) as
shown here.
3.
Replace the cover.
CAUTION
Only use AA alkaline batteries.
Dispose used batteries according to local ordinance regulations.
Remove the batteries when not using the projector for prolonged periods.
1.
2.
3.