5.6.2 Check signal quality
IMPORTANT
Recommended signal strength
The signal strength in WaveNet should be at least -85 dBm or higher. If the
signal strength is insufficient, the connection between the devices may be
slow or interrupted.
If the signal strength is poorer than -85 dBm, then improve the signal
quality (see
Improving signal quality [}143]
).
Unit of signal strength
The WaveNet Manager displays the signal strength as an RSSI value
(Received Signal Strength) in dBm. This value is:
Logarithmic: In practice, an improvement of 10 dBm means twice the
signal strength.
Negative: The theoretical best value is 0 dBm and is only achieved by
cable connections. The closer the value is to 0 dBm (i.e. the smaller the
amount), the better the reception.
Single RouterNode
ü WaveNet Manager opened via LSM (see
Best Practice: From the LSM
software [}37]
)
ü RouterNodes and LockNodes connected to WaveNet (see
Finding and
adding devices [}48]
).
1. Right-click the entry of the RouterNode whose signal quality to its
LockNodes you want to check.
9 The window "Administration" opens.
WaveNet (Manual)
5. WaveNet Manager
171 / 210
To Next Page
Loading...