Simrad AP25 Autopilot
128 20221495F
Autotrim
standard value is 40 sec. which should work well on
most boats.
Rudder Limit
should be kept at 20 degrees unless there is a
need for more rudder when performing dockside manoeuvres.
Recall Autotuned?
To recall the parameter values
that were achieved during the
Automatic tuning procedure,
rotate the course knob
clockwise. When parameter
values are recalled, Confirmed
is displayed.
Exit the Parameter menu by pressing STBD button to proceed to
the Service menu, or press STBY to return to normal AP25
operation.
4.9 Service Menu
Select STANDBY mode and then enter the Installation Menu by
pressing and holding the INFO/SETUP button for 5 seconds.
Select "SERVICE" by pressing the STBD button and confirm by
rotating the course knob clockwise.
System data and NMEA data
are test functions to analyze
data processed by the AP25.
Sn 00000 is the unique
SimNet ID number for the
specific autopilot control unit.
To exit the menu, press any
mode key (STBY, AUTO or
NAV).
Correct setting of counter
rudder, ideal response
To Next Page
Loading...
Need help?
General
