Simrad AP25 Autopilot
96 20221495F
The display will read ‘SETUP
REQUIRED’.
Continue with the installation setup
according to the next chapters.
If you already have completed the
installation settings, the autopilot
will enter STBY mode.
4.2 Description of Installation Settings
Note ! The installation settings must be performed as part of the
installation of the AP25 system. Failure to do so correctly may
prohibit the AP25 from functioning properly!
The Installation menu can only be accessed in STBY mode.
The Installation Settings are grouped into the following
functional categories:
• Language: Selection of language used for display
information
• Dockside: Items to be set prior to sea trials
These will vary depending on the type of
feedback the autopilot will use (page
67, 100,
109)
• Interface: Setting the format of the clock/data output for
radars connected to the Autopilot Computer.
• Display units: Setting the units to be displayed for wind
speed, water temperature and depth.
• Sea trial: Presents settings and automatic calibrations to
be performed during sea trial.
• Parameters: Permits viewing and changing of basic
steering parameters (See also Response
control, page
56).
• Service: System data, NMEA data, NMEA test,
SimNet setup, Master reset of memories.
Each group is designed to focus on specific functions, and enable
quick access when changes need to be made.
To Next Page
Loading...
Need help?
General
