Simrad ES60 - INSTALLATION REV A - General Purpose Transceiver Specifications

Technical specifications
• Outputs:
– Echogram printer (Centronics parallel or USB depending
on computer make and model)
– Bottom depth (Serial line, NMEA format)
– Depth data (Serial line, NMEA, Simrad or Atlas formats)
•
Inputs:
– Navigation receiver (Serial line, NMEA format)
– Motion sensor (Heave, roll and pitch)
– Analogue heave, roll and pitch (+/- 10 V)
– Annotation
– Transmit synchronization
– Temperature sensor
•
Remote control toggle switch:
– Survey Line
– Remote power
– Transmit synchronization
General Purpose Transceiver specifications
• Transmit power:
– Max 2 kW (Dual frequency G PT)
– Max 4 kW (Single frequency GPT)
•
Receiver noise figure: 3dB
•
Transducer impedance: 60 ohms
•
Output protection: Short circuit and open circuit protection
•
Receiver input range: Instantaneous dynamic amplitude range
-160 dBW to -20 dBW (dB relative to 1W)
•
Connectors:
– Transducer: 12-pin female Amphenol, Shell MS3102A-24,
Insert 24-19S
– AUI: 15-pin female Delta
– Network: 8-pin RJ-45 socket
– Auxiliary: 25-pin female Delta
•
Physical dimensions:
– Width: 284 mm
– Height: 112 mm
– Depth: 246 mm
– See also: GPT Outline dimensions on page 100
304699/A 107