Interfaces and integration
2 On the ES60 computer, connect the receive signal Rx on
pin 2, the transmit signal
Tx on pin 3, and ground on pin 5.
3 On PI44 and PI54, use either connector
NMEA1 or NMEA2.
Connect the receive signal
Rx on pin 8, the transmit signal
Tx on pin 6, and ground on pins 7 and 9.
4 On PI30 and PI32, use connector
NMEA. Connect the
receive signal
Rx on pin 3, the transmit signal Tx on pin 1,
and
ground on pins 2 and 4.
5 Ensure that the length of the cable does not exceed
approximately 50 meters. If a longer cable is required, you
may need to use buffer amplifiers on the serial li n e.
Setup procedure
1 On the ES60, access the Install menu, and open the Purse
Interface
dialogue box.
2 Click the
RS232 button to open the RS232 Setup dialogue.
3 Enter the identification of the RS-232 port you have used
to make the c onnection.
4 Enter the correct comm
unication parameters, and click
OK.
5 Ensure that the transmit parameters on the PI system
matches the receive parameters on the ES60.
6 Click the
Depth output button to open the Depth Output
dialogue.
7 Click
Depth output to enable the communication.
8 For
Telegram, select $SDDBS.
9 Click
Ok to exit the Depth Output dialogue.
10 Click
Ok to exit the Purse Interface dialogue.
Related topics
Generic RS-232 Serial line cable on page 47
Cable between PI44/54 and echo sounder on page 65
Cable between PI30/32 and echo sounder on page 66
Input interfaces
The following interfaces are set up to receive information from
external devices.
• Navigation system
• Heave sensor
• Temperature sensor
304699/A 89
To Next Page
Loading...
