Installation procedures
General Purpose Transceiver installation
The General Purpose Transceiver (GPT) is a self-contained unit.
It can be mounted anywhere on board the vessel. It is however
recommended to mount the GPT as close to the transducer(s) as
possible in order to minimize the electrical interference in the
transducer cable.
The GPT is easily mounted with the brackets supplied with the
unit.
Preparations
Two brackets and four pan head screws are enclosed. The side
walls of the unit each hold six screws; three screws along the
bottom edge and three screws along the top edge. The brackets
can be vertically mounted in three different positions;
• Use the two rear holes, or
• Use the two centre holes, or
• Use the two front holes.
The brackets can be horizontally mounted in four different ways
using e ither the bottom edge holes or the top edge holes.
The brackets can be horizontally mounted in four different ways
using e ither the bottom edge holes or the top edge holes.
Procedure
1 Unscrew two screws from each side wall.
2 Mount the brackets using the pan head screws.
3 Position the unit on the surface and mark the four mounting
holes.
4 Remove the unit, and drill mounting holes.
304699/A 31
To Next Page
Loading...
