Simrad ES60 - INSTALLATION REV A - Single Beam, Normal Power Transducer

Simrad ES60
Single beam, norm al power transducer
This is the termination of the transducer cable from a single
frequency, single beam transducer to the t ransducer socket on the
General Purpose Transceiver Unit (GPT). The other end of the
cable is permanently fixed to the transducer.
Normal power output (1 kW) is achieved w hen the GPT is
equipped with a single transmitter board.
M
E
F
J
H
D
C
K
L
A
B
N
Transducer
cable
D
C
Junction Box (1:1)
(Optional)
GPT Transducer
socket
Screen
Drain wire
Connect to plug housing
W802-1
Rev.E
Single frequency, single beam, normal power termination
If you need to splice the transducer cable, it is very important to
use the correct cable, and to avoid ground loops. We strongly
recommend the use of a junction box. We also recommend that
you install the transducer cable in a steel conduit.
Related topics
Cable splicing on page 140
Steel conduit on page 140
GPT Transducer plug connection on page 105
68
304699/A