Simrad HS52 GPS compass and DGPS navigator
26 20222360 / E
3.9 Software Setup Procedure
This chapter describes a number of basic installation settings
that must be performed as part of the Simrad HS52 installation.
Some of these settings may also need to be changed during
operation. In addition to the basic installations settings, a
number of advanced setting are available. The advanced settings
are described in chapter 3.10. Failure to correctly set the values
in the installation settings may prohibit the product from
functioning properly.
Before attempting to turn on the Simrad HS52 product and
perform an installation setup, the hardware and electrical
installation must be completed in accordance with the
installation instructions.
The SETUP menu is entered on the Display unit by pressing and
holding the SETUP button for 5 seconds.
The settings are grouped into the following submenus:
• Display adjustments
• Diff. corrections
• SBAS setup
• Activate
• Discard
Use the arrow buttons to select category, and the
rotary knob to enter a submenu.
To Next Page
Loading...
Need help?
General
