Simrad HS52 GPS compass and DGPS navigator
18 20222360 / E
3.6 Processing Unit
The Processing unit is not waterproof and should be mounted
vertically in a protected place. Reserve sufficient space below
the unit to allow insertion for cable connections.
It is recommended that ventilation or air conditioning is
provided in order to keep the ambient operating temperature
below +55ºC (+130ºF). The best location is typically in the
instrument room or on the bridge.
Dimensions for the Processing unit are shown on page 65.
Use the supplied mounting screws for fastening the Processing
unit as shown on the figure below.
Cable Connections
Proceed as follows to connect the cables to the Processing unit:
1. Remove the bottom cover (terminal cover) to get access to
the plug-in terminals.
To Next Page
Loading...
Need help?
General
