Simrad HS52 GPS compass and DGPS navigator
42 20222360 / E
FUNCTION
REF.
PAGE
The rotary knob is used for entering values in SETUP
submenus, and for adjusting the display brightness.
21
4.2 Turning the System ON/OFF
A single press on the POWER button switches the system ON,
and the following start up information is shown on the display:
Once installed, calibrated and started, the HS52 needs no
manual intervention during operation.
After power on, up to 2 minutes is needed for full position
accuracy and up to 10 minutes for full heading accuracy is
obtained. Since there normally is no reason for turning the unit
off, it should be left running continuously.
The HS52 will be shut down in a controlled way when the
POWER button is pressed for 1-2 seconds. Then the message
Shutdown in process will appear on the screen. If the POWER
button is pressed and held for 5 seconds or more, the system is
shut down immediately. Typically used if the system has a hang-
up and does not respond on any commands. The configuration
of HS52 is however stored on the internal flash disk independent
on how the unit is powered off.
4.3 Performance Monitoring
The navigation display NAV1 and NAV2 includes on the left
side of the screen data quality and status information. The
indicators are as follows:
To Next Page
Loading...
Need help?
General
