6.2 Acknowledging an alarm
An alarm is acknowledged by pressing any key. This will
remove the alarm notification (text, light and sound)
from all units that belongs to the same alarm group.
Refer to SimNet group function, page 23.
A reminder will reappear at given
intervals as long as the alarm
condition exists.
An alarm received from other SimNet units must be
rectified on the unit generating the alarm!
6.3 Viewing active alarms
A list of any existing alarm condition may be displayed at
any time.
6.4 Alarm codes
If the alarm is received from other units connected to
SimNet, the alarm text may not be displayed. The alarm
condition will then be indicated with a code.
A description for available codes are listed in the table on
next page.
44 | IS20 Alarm system
To Next Page
Loading...
