Simrad IS20 User Manual

Turn rate too high,
turning cw
Turn rate too low,
turning cw
4. The automatic calibration is completed when the
information window disappears from the display
Heading offset
After compass calibration, the heading should be checked
against a known reference, a compensated compass or a
bearing.
If the compass reading has a fixed
offset, use the Offset parameter to
compensate.
Range Change per step Default value Units
-180 - +180 1 0 °
64 | Configuration

Simrad IS20 Specifications

General

Brand	Simrad
Model	IS20
Category	Marine Equipment
Language	English