30 |
Operating procedures | RS90S User Manual
• Dual watch scan
Scans the selected channel and channel 16.
• 3CH scan
Scans your three favourite channels and the priority channel.
• Tri watch scan (US models only)
Scans the current channel, channel 16 and channel 9.
ALL SCAN mode
Hold down [SCAN] for about 3 seconds to start ALL SCAN mode.
The radio displays the SCAN icon and “ALL SCAN.” You will see the
channel numbers changing.
• If you hear a communication of interest, press [SCAN] or [PTT] to
stop at the currently scanned channel.
• Press [X] to quit scan mode and return to the previously selected
channel.
¼ Notes:
• Scan is not allowed in some EU countries.
• If TONE ALERT or SAME is enabled (US models only), the weather
channel is also scanned.
Skipping busy channels
If one channel is always busy with traffic, you can set the radio to
skip that channel during scanning.
To skip a channel:
• While the channel is displayed during scan, press [OK] to skip over it.
To resume scanning a skipped channel:
• With scanning OFF, as you scroll up and down through channels, the
SKIP icon will be displayed when you are on a skipped channel. With
the SKIP channel selected, press [OK] to cancel the SKIP function.
¼ Notes:
• You cannot skip the priority channel.
• The SKIP icon will disappear when the radio is powered OFF/ON.
To Next Page
Loading...
Need help?
General
