Simrad RS90S User Manual

58 |
DSC procedures | RS90S User Manual
• Do nothing to allow the radio to automatically switch after 10
seconds, or
• Press [X] to cancel the automatic switch and remain on the
current channel.
4. When needed, press [PTT] to talk on the selected working channel.
AUTO ACK
(For Individual calls with INDIV REPLY set to Auto)
When the radio sounds the incoming DSC call alert:
1. Press the [SILENC] softkey to silence the alert.
2. To see more details about the call, including the requested channel,
press ▲ or ▼.
3. You can then use one of the following three softkeys:
• [ABLE]
Acknowledge the call on the requested channel.
The radio will send the acknowledge signal and change to the
designated channel.
• [NEW-CH]
Acknowledge the call, but request a different channel:
• Press ▲ or ▼ to reach the channel you want to use, and then
press the [ABLE] softkey.
The radio will send a request for your preferred channel.
¼ Note: AUTO ACK is not allowed in some EU countries.
• [UNABLE]
Acknowledges the call, but signals that you are unable to use the
requested channel. Note: this option is not available for ROUTINE
calls. If INDIV REPLY is set to AUTO, the radio will automatically
send an acknowledgement to the caller if there is no user
intervention within 10 seconds.
• When needed, press [PTT] to talk on the selected working
channel.
Receiving a DSC distress call
See “DSC Distress calls” on page 42.
D
INDIVIDUAL
ROUTINE FROM
SUNBIRD
NO AUTO SW
01:15
L
ASU
CNS
C
16
Hi
DSC
PRI
SILENC
INDIVIDUAL
ROUTINE FROM
SUNBIRD
NO AUTO SW
01:15
NEW-CH ABLE
C
16
Hi
DSC
PRI
ROUTINE FROM
SUNBIRD
NO AUTO SW
CH09 REQUEST
01:15
ASU
CIS
NEW-CH ABLE
C
16
Hi
DSC
PRI
INDIV ACK
CHANGE CHAN
SET CHANNEL
Lo
USA
ABLE
C
08
DSC

Simrad RS90S Specifications

General

Brand	Simrad
Model	RS90S
Category	Radio
Language	English