| 61
DSC procedures | RS90S User Manual
Receiving a response to a DSC LL request
When you receive GPS data from a buddy in response to your LL
request you should make a written note of the position.
1. Press [SILENC] softkey to silence the alert.
2. Press ▲ or ▼ view further information about the call.
3. When finished, press [X].
¼ Notes:
• To send an LL request, see “Sending an LL request for the position of
a buddy” on page 52.
• LL request data is not stored on the RS90S.
Receiving a DSC test call
You can set up the radio to respond to incoming DSC TEST calls with
an automatic response or manual response. To change the option,
see “Setting up DSC test reply” on page 100.
Manual response
1. On receiving a DSC test request, the radio sounds a two-tone alert.
2. Press the [SILENC] softkey to silence the alert.
3. Press the [ACK] softkey to acknowledge the DSC Test Call.
Auto response
On receiving a DSC test request, the radio automatically replies after
a 10 second delay with an ACK signal.
To Next Page
Loading...
Need help?
General
