| 11
Component overview | SRT LAN radar sensor S-band down-mast Service Manual
Connector Purpose
TB6 Cable for the optical read-out connection
TB2 Motor signals
P1 Controls to SRT PWR-DC
TB7 Accelerometer data signal
P2 Power from SRT PWR-DC
J12 Lan connector
J15 Trigger pull
J18 Trigger push
J17 Magnetron current
P3 Signal to display
TB8 Safety switch connector
J19 Video out
J14 Video in
J11 Tuning input
TB3 Signal from/to LNFE
J5 Noise source
J1 Noise detect
SRT PWR-DC PCB
E
B
C
F
D
A
Label Purpose
A P1 PW_ON (normally open, closed puts the TXRX in STBY)
B DL2 LED ON (green): + 5,1 V DC OK
C DL3 LED ON (red): High voltage OK (700 V DC for modulator)
D R27, R32, R42 Modulation H .V. Adjustments factory made
E DL1 LED ON (green): + 52 V DC input OK
F TB2 Main power input
To Next Page
Loading...
