Singer 93234 - FASTENING THE BUTTONHOLE ATTACHMENT; SETTING THE LENGTH OF BUTTONHOLE

\
2
4
A
3
B
RECOMMENDED SETTINGS
Stitch Selection:
Stitch Width:
Stitch Length: .
Foot:
Needle Plate:
Buttonhole Stitch
= 1;
' I ,l,,,l_,fi_
Buttonhole Attachment (L)
General Purpose (A)
Fastening the Buttonhole Attachment
• Remove-presser foot from shank.
• Place buttonhole attachment behind
shank and guide it forward.
• Center pin (1) in attachment under
shank, and lower presser foot lifter.
• Press presser foot screw down firmly
until shank snaps into place:
Setting the Length of Buttonhole
• Open button clamp (2) and place but-
ton on carrier (3).
• Slide clamp (2) back to hold button in
place.
• Raise foot lifter and draw needle thread
(A) and bobbin thread (B) between upper
(4) and lower (5) plates of button attach-
ment, and to the back of machine.
• Place fabric between upper and lower
plates.
• Center 3 red guidelines (6) of attach-
ment around beginning line of button-
hole.
Lower presser foot lifter.
Push foot from back of button carrier
(7) toward you to insure proper button-
hole length.