SinoGNSS M300 Plus GNSS - Receiver Configuration; General Config; Antenna Setup

To Next Page

To Previous Page

M300 Plus GNSS Receiver User Guide

4.3 Receiver Configuration

Use configuration menu to do basic configurations of your receiver.

4.3.1 General Config

There are 2 work modes you can choose:

 Base station: configure the receiver as a Base station, you can change its

settings in Base Setup menu

 Rover: setting the receiver as a rover, and Base Setup menu is not available

for rover mode.

Also, active the external input/output as 1pps, please enable Event Marker and

External clock only when the external clock or events are connected.

4.3.2 Antenna Setup

Enter the proper values of marker name and antenna height (height limited 0 to

6.5535m), select the antenna type and measurement method.