SinoGNSS M300 Plus GNSS - Base Setup

M300 Plus GNSS Receiver User Guide
14
4.3.3 Base setup
After setting the work mode as base station, the base setup menu is available for you.
However, you can change the base setup only when it’s on manually start station
mode with stopped status.
To configure the base station:
 Change base start mode from automatically to manually -> press enter,
ensure that Base Start Mode is on manual
 Press Stop to restart editing
 Then input coordinates of known sites, or press Get Position button to get
coordinates of the current position

Set proper base station ID based on your project planning
 Change base start mode from manually to Automatically, then click Start to
active configuration