SinoGNSS M300 Plus GNSS - Direct Connection Model; Ntrip Config

To Next Page

To Previous Page

M300 Plus GNSS Receiver User Guide

4.6.2.1 Direct connection model

The M300Plus provides a more machine friendly method for users to check and

configure receivers by TCP/IP. This function only can be used in TCP/IP1.



Enable Active button

 Enter TCP server port



Select Direct connection in data flow

 Click Enter button

Then connect it by TCP Client in CRU software.

For programmatic commands, Please refer to 5.1 Frequently used commands.

4.6.3 Ntrip Config

The M300Plus can support Ntrip Client, Ntrip Server and Ntrip Caster protocols. You

can acquire correction data from CORS through Ntrip Client protocol if setting the

receiver as a rover. It is also very easy to transmit correction data as the base station

by using Ntrip Server and Ntrip Caster protocols.

For a base station, you can broadcast correction data by using Ntrip Server protocol

or the data forward software (supporting Ntrip Caster protocol, such as SinoGNSS’s