SinoGNSS M300 Plus GNSS - Page 39

M300 Plus GNSS Receiver User Guide
35
 Change the serial port baud rate
com com1 9600// Change the baud rate of com1 to 9600
 Check System Information
log sysconfiga //All the configuration of the system can be viewed by this
command.

Check the Output data Information
log loglista//View the output data information about all the ports.

Lockout/unlockout satellite system
Command
Description
(un)lockout bd2
(un)lockout Beidou system
(un)lockout gps
(un)lockout GPS system
(un)lockout GLONASS
(un)lockout Glonass
Unlockoutall
Unlock all GNSS system
 NMEA data output
The serial port is for COM1, you can output any NMEA data through COM1.