Sirman PLL 300 - Using the Slicer; Operational Checks Before Use

18
CHAP. 5 - USING THE MACHINE
5.1 - OPERATIONAL CHECK
When the slicer is used for the first
time, proceed with the following
instructions:
- c
heck the slicer is correctly installed refer to
chap. 2;
- check that the hopper is securely fastened
utilising the lock knob (Fig. n°36 ref.1);
- check the hopper travels freely and there are
no obstacles on the counter (Fig. n°37 ref.a);
- check the product pusher can be raised
and lowered easily and movement is not
impeded in any way;
1
Fig. n°36
Fig. n°37
- c
heck the thickness gauge opens and
closes correctly by turning the thickness
selection knob clockwise and anti-clockwise
(Fig. n°38 ref.c);
c
Fig. n°38
- c
heck the sharpener is securely fastened
to the machine and can be easily
removed and free of obstacles (Fig. n°39
ref.d).
Fig. n°39
d
a
b