26
CHAP. 7 - MAINTENANCE
7.1 - FOREWORD
Before performing any maintenance operation:
a) Disconnect the plug from the mains to isolate the slicer from the mains power supply.
b) Turn the thickness selection knob to “0”.
7.2 - BELT
The belt does not require adjustment. Generally after 3/4 years it must be replaced. Contact
your local “SERVICE CENTRE” for replacement”.
7.3 - FEET
The support feet can deteriorate in time and lose their elasticity, causing loss in stability. To
r
eplace contact your local “SERVICE CENTER”.
7.4 - POWER SUPPLY CABLE
Periodically check for wear in the power supply cable. If the power supply cable shows signs of
wear or damage contact you local “SERVICE CENTRE” for a replacement.
7.5 - BLADE
After numerous sharpening and dressing operations check blade diameter. The diameter must not
exceed more than a 10 mm reduction tolerance in respect to the original diameter. Contact you local
“SERVICE CENTRE” for a replacement.
7.6 - GRINDERS
Check that the grinders maintain their abrasive property during sharpening. Grinders that are
no longer abrasive must be replaced to prevent damaging the
blade. Contact you local “SERVICE CENTRE” for a replacement.
7.7 - SLIDING GUIDES LUBRICATION
Occasionally put a few drops of oil (from the tube provided) on the round bar the hopper assembly
slides back and forth on, through the hole (OIL) located on the side of the thickness selection knob.
7.8 - PUSHBUTTON PANEL LABEL
The pushbutton panel label can be damaged in time. Contact you local
“SERVICE CENTRE” for a replacement.
To Next Page
Loading...
