27
7.9 - ERROR CODES
If one of the following error codes comes up on the display proceed with the instructions provided to
r
emedy the fault. In the event it is not possible to remedy the fault, contact your local “Authorised
Service Centre”.
Error code
Cause Re edy
E1
Motor failure
-
-
Check
encoder wiring and
connection
Check motor wiring and
connection
- Check
for mechanical failure
E2
“Slice” count set at “0” with the
slice counter function activated
- Set requ red number of slices .
E3
Home search unsuccessful
- Check encoder wiring and
connection .
- Ch
eck motor wiring and
connection.
- Check end of travel magnet on
hopper assembly.
E4
Hardware error
- Check communication between
power supply and keypad.
E5
Motor does not cut-in
- Check
encoder wiring and connection.
- Check motor wiring and connection.
- Check for mechanical failure.
E6
Overcurrent in motor driver
- Check lubrication.
- Check weight and quantity of food
product being sliced.
To Next Page
Loading...
