SITA Messtechnik GmbH - Operating Instructions SITA ConSpector
You can pre-clean the immersion probe with a mild cleaning solution. To do so, please
prepare the measuring arrangement with screwed-on limiter and using the cleaning so-
lution instead of a sample.
Use demineralized water to rinse off cleaning agents and other residues after cleaning
using water. Check the result (see ‘Checking the device’) and repeat the cleaning process
if necessary.
Please clean the stainless steel beaker after use.
For a detailed cleaning, e.g. after a failed test/empty
measurement, you can also carefully unscrew the lim-
iter of the immersion probe. Then clean the end of the
glass rod. Cotton swabs soaked in alcohol or water are
suitable for this purpose. Avoid damaging the glass
rod.
For more information on cleaning, see the operating instructions in chapter 8.2.
To Next Page
Loading...
