SITA Messtechnik GmbH - Operating Instructions SITA ConSpector
1 Intended use
Please read these instructions completely before use and follow the safety instructions. No warranty
or liability will be accepted by SITA Messtechnik GmbH for any damage caused by improper han-
dling of the device or its components. Pay special attention to the following information:
Check the intactness of the device and the accessories and the compliance with the scope of
delivery and the packing list immediately after receipt.
Keep these operating instructions handy for all users.
Use the device for no other purposes than that specified in these operating instructions. Any other
use may cause hazards or damage. No liability for such damage will be accepted by the manu-
facturer. The user will bear the risk exclusively.
Attention: The radiation emission is in a non-hazardous range (EN 62471, free
group). Nevertheless, do not expose yourself directly to the invisible ultraviolet ra-
diation emerging from the immersion sensor of the sensor head. Avoid looking di-
rectly into the ray outlet opening.
Do not open the device (exception: battery replacement, see section 8.4), otherwise all warranty
claims will be voided. Any repair of open devices usually involves higher testing and repair costs.
Read the operating instructions and additional instructions, if any, prior to installation, start-up and
maintenance
Avoid any mechanical damage, especially to the display and the light conductor but also electrical
lines.
Avoid strong light irradiation or rapid light changes during a measurement.
Only the immersion sensor should come into contact with the liquids.
Make sure the sensor housing
and the basic device do not come into contact with acids/alkaline solutions as well as organic
solvents. In case of doubt, test the chemical resistance of the SITA ConSpector according to the
material specifications (see section 4.2).
Do not use the device in a corrosive environment.
Avoid any extreme stress, such as high temperature or high air humidity. Allow the cold device to
adapt to room temperature before you switch it on.
To operate the device, always use USB-conforming interfaces or the original power pack supplied.
Should problems occur, contact the manufacturer of the device or your dealer.
To Next Page
Loading...
