TUNE YOUR RIDE
138
mmr2015-142-003_a
TYPICAL - PROPER ADJUSTMENT
A. Suspension fully extended
B. Suspension has collapsed with operator, passenger and load
added
C. Distance between dimension “A” and “B”, see table below
C What to do
50 mm to 75 mm (2 in to
3 in)
No adjustment required
More than
75 mm (3 in)
Adjusted too soft. Increase
preload
Less than
50 mm (2 in)
Adjusted too firm. Decrease
preload
Note: If the specification is unattainable with the original
springs, see an authorized Ski-Doo dealer for other available
springs.
rMotion Without Quick Adjust
To increase spring preload using tool, always turn the left side
adjustment cam in a clockwise direction, and the right side
cam in a counterclockwise direction.
CAUTION
Never set preload cams directly from position 5 to 1 or directly
from position 1 to 5.
To Next Page
Loading...
Need help?
General
