MAINTENANCE PROCEDURES
196
Track Tension Adjustment
1. Remove tether cord cap from engine cut-off switch.
CAUTION
Use proper lifting techniques, notably using your legs force.
Do not attempt to lift the rear of vehicle if it is above your limits.
2. Remove wheel caps.
3. Loosen the rear axle screw or, on 2 idler wheel models,
the rear axel nut.
4. Tighten or loosen both adjustment screws (equally) to
increase or decrease track tension.
520001663-027_a
Step 1: Remove cap
Step 2: Loosen the axle screw or nut
Step 3: Tighten or loosen adjustment screws
5. If correct tension is unattainable, contact an authorized
Ski-Doo dealer.
6. Retighten the rear axle fasteners to specification.
To Next Page
Loading...
Need help?
General
