Ski-Doo REV G4 Trail/Crossover E-TEC Series User Manual

MAINTENANCE PROCEDURES
198
1
2
3
1. Guides
2. Slider shoes
3. Equal distance
4. To correct track alignment:
4.1 Stop engine.
4.2 Remove tether cord cap from engine cut-off switch.
WARNING
Remove tether cord cap from engine cut-off switch
before performing any maintenance or adjustment,
unless otherwise specified. Vehicle must be parked in
a safe place, away from the trail.
4.3 Loosen the rear axle nut.
4.4 Tighten adjustment screw on side where the slider
shoe is the farthest from the track insert guides.

Ski-Doo REV G4 Trail/Crossover E-TEC Series Specifications

General

Brand	Ski-Doo
Model	REV G4 Trail/Crossover E-TEC Series
Category	Snowmobiles
Language	English