STORAGE
215
6. Again, press and hold the SET (S) button for 2 - 3 sec-
onds.
Note: The gauge will display OIL when the storage procedure
is initiated.
7. When gauge displays OIL , release button and wait for
the lubrication function to end.
619900974-807
TYPICAL - 7.2" DIGITAL DISPLAY SHOWN
Do not touch anything during engine lubrication cycle.
The engine lubrication function takes approximately 1 minute.
During this time the engine RPM will increase slightly to
approximately 1600 RPM and the oil pump will "oil flood" the
engine.
At the end of engine lubrication procedure, the ECM will turn
the engine off.
Remove tether cord cap from engine cut-off switch.
NOTICE Do not start the engine during storage period.
To Next Page
Loading...
Need help?
General
