CONTROLS, INSTRUMENTS AND EQUIPMENT
91
Unit Selection
This multifunction gauge is factory preset in Imperial units but
it is possible to change it to Metric units.
Using MENU button, Select UNITS and hold button to change
units.
Setting Clock
Using MENU button, Select CLOCK and hold to change units.
1. Press MENU button to select clock display.
2. Push and hold MENU button for 1 second.
3. Press MENU button to select 12:00 AM PM or 24:00
time base.
4. Push and hold MENU button or OK button to acknowl-
edge selection.
5. Press MENU button to change hours (hours flash).
6. Push and hold MENU button or OK button to acknowl-
edge hour selection
7. Push MENU button to switch to minutes (minutes flash).
8. Press MENU button to change minutes.
Setting Language
The gauge display language can be changed. Refer to an
authorized Ski-Doo dealer for language availability and to
setup the gauge to your preference.
Warning Lamps and Indicators
The following indicator lamps will alert you to a vehicle con-
dition that may become serious. Some lamps will illuminate
when starting the vehicle to make sure they work. If any lamps
remain on after starting the vehicle, refer to the respective
system warning lamp for further information.
Note: Some warning indicators appear in the display of the
multifunction gauge and function the same as an indicator
lamp but do not display when starting the vehicle.
To Next Page
Loading...
Need help?
General
