Page 48 of 60
2018-05-28
Installation DL2 Doppler Speed Log System
CHAPTER 6: SOLVING PROBLEMS
The following section covers envisaged problems with the system.
The DL2 sytsem consists of 3 software packages, All of these can be upgraded via the LAN interface.
To do this download the SKIPPER service software from www.skipper.no. Install this on a PC and
then connect to the unit, either through the ships network or directly. Then follow the instructions in
the software.
As this product is new, there will be frequent improvements added to the software. Please monitor
the SKIPPER web site to see if these are useful for you.
To upgrade select Come setup and search for systems. Check you can see the systems you are
connected to. Set your PC’s Network settings to Static ip address with address 172.16.1.95
Search with the software.
Close this window and go to the JB70D2 window. Search for the part to be uograded.
Press Download Firmware and follow the instructions
If you do not see the system you are connected to, type the IP address into the lower window. and
select the system type (Default JB70D2 is 172.16.1.101, CU-M001 is 172.16.1.102
Then select the software
SW-M004 for JB70DL2 Electronic unit
SW-M005 for CU-M001 Display
More updated information will be available on the SKIPPER forum (www.skipper.no/smf) and in the
data bullitins
To Next Page
Loading...
Need help?
General