General information8
With some of the menus you can enter a free text. For instance, when allocating a
folder name for storing MP3 data on the hard disk or when searching for the name of
a special destination.
– Press to accept a character sequence offered by the system or press to
delete the characters in the entry line.
– When in the entry window, press on a character shown on the keypad block to
accept it into the entry line.
– You can also delete or change the character sequence in the entry line as well as
insert additional characters.
– Press to accept the indicated character sequence in the entry line. By pressing
the input mask will be closed without the entries being accepted.
Further input possibilities:
- changes from upper case to lower case and vice versa.
- opens the input mask for digits and special characters. The function key changes
to . Press , to change again to the letter input mask.
- space key for entering spaces.
or - moves the character entry cursor (the cursor) in the entry line to the left or
right.
- deletes characters in the entry line starting from the position of the character
entry cursor from right to left.
Selecting letters based on specific characters
Some letters in the input masks are also marked with a small triangle “a”. This indi-
cates that specific characters based on this letter can be selected.
Continue to press down on the corresponding function key with your finger until a
pop-up window with these specific characters can be displayed. Press to accept the
desired character into the entry line - the pop-up window will close. If no entries are
entered, the pop-up window will close automatically after a few seconds.
Some specific characters can be “written out”. The navigation system will also recog-
nise the character sequence “AE”, “UE” and “OE” instead of the German specific char-
acters “Ä”, “Ü” and “Ö” vom Navigationssystem erkannt. Other specific characters can
be ignored, for example instead of “É”, “Ê” or “È” a normal “E” will be accepted by the
navigation system.
Input mask for digit entry
– Press to accept an indicated character sequence or press , to delete the
characters in the entry line from right to left.
– Press one of the to function keys in the input mask to accept the corre-
sponding digit into the entry line.
– Press when the correct number is indicated in the entry line. By pressing
the input mask will be closed without the entries being accepted.
Special functions*
Parking aid
If your vehicle is equipped with “parking aid” and after it is activated, the distance to
the obstacle is shown on the screen.
OK
OK
y
:
;
A-Z A-Z
b
Fig. 4 Input mask for digit entry
OK
0 9
OK y
s32k.a.book Page 8 Friday, September 18, 2009 1:54 PM
To Next Page
Loading...
Need help?
General
