Range selector key NAV (Navigation) 35
Update navigation data in the unit
– If the data of the navigation DVD is not identical to that stored in the navigation
memory of the unit, a corresponding message will be displayed.
– Press on the function key to overwrite the data in the navigation system
memory of the unit with the data from the navigation DVD.
Use data of a navigation DVD for a short period of time
– If you leave the stored area map in the navigation memory of the unit for only a
short period of time, insert the navigation DVD for the area to be driven.
– Press on the function key and leave the navigation DVD in the unit.
The unit uses only the data from the navigation DVD for the navigation.
– If you are again in the area of the map material stored in the navigation memory,
press the key to take out the navigation DVD.
Storing the navigation data can take up to one hour. Route guidance will start via the
navigation DVD while the navigation data is being stored. Please note that route guid-
ance will be interrupted if the navigation DVD is taken out. Route guidance must then
be restarted with details supplied from the navigation system memory of the unit.
Up to date navigation data and new navigation DVD
Road guidance is subject to constant changes (e.g. new streets, changes of street
names and house numbers). A navigation DVD is a huge data store, which unfortu-
nately will not be up to date after a certain time. This can lead to complaints during
route guidance.
It is for this reason that you must regularly update the navigation data on your unit with
a current navigation DVD.
Input windows of the navigation system
Selecting a destination from the list
– If you press on the function key after opening the input mask, a list will open
with all the destinations containing the relevant parameters selectable from the
navigation memory (e.g. and ).
– If need be, move the sliding regulator to the right edge of the touch-screen for all
entries in the list to be displayed.
– Press the desired entry in the list to take it over for the address.
Limit destination and select from the list
– You can open a list of the selectable destinations any time by pressing the function
key while entering a destination in the entry line. Only destinations selectable
from the navigation memory which correspond to the requirements and the char-
acter sequence in the entry line will be displayed.
– The number of selectable destinations will be displayed in the function key if
fewer than one hundred destinations can be selected.
– If fewer than six destinations are selectable, the entry window will close automati-
cally and a list of possible destinations will be displayed.
Main menu Navigation
Save
Te mp or ar ily
#
Country City
**
**
Fig. 14 Main menu Navigation
with address.
s32k.a.book Page 35 Friday, September 18, 2009 1:54 PM
To Next Page
Loading...
Need help?
General
