Range selector key RADIO 17
Save radio station
– Press on the function key while in the main menu Radio ⇒ page 16, fig. 7.
A pop-up window with a range of memory space groups is opened.
– When you select a memory space group, a menu for saving six radio stations is
opened.
– Select a memory space and save the station by pressing on the memory space.
– If a memory space is selected, which already holds a radio station, it will be
overwritten.
Calling up a saved radio station
If the currently heard radio station is already saved in the preset list, the memory space
number is displayed behind the description of the frequency range (FM or AM).
Calling up a station via the station keys
– Briefly press on one of the six station keys to displayed in the main menu
RADIO until a signal tone sounds.
Select stations from the preset list
– In the pop-up window, select the station keys to be displayed in the main menu
RADIO.
– Press the display of the desired station in the preset list.
RDS function
RDS (“Radio Data System”) serves to transmit program identification and additional
services therefore also enabling automatic tracking of stations.
In the event of sufficiently satisfactory reception, the suitable RDS radio stations will
display the station name instead of the station frequency.
If a radio station sends additional information via the RDS function while a station is
being stored, it can occur that the name of the radio station is later displayed incor-
rectly in the preset list.
Change station name
You can manually adapt the station name.
Choose the stored radio station and wait until the correct name is displayed on the
touch-screen. Continue to press on the display of the station name between the arrow
keys until “Station name stored” is displayed.
Traffic programme function TP
Switching traffic programme TP (TMC Program) on or off
– Press the range selector key to call up the RADIO main menu.
– Press the function key .
– Briefly press on in the opening pop-up window to switch the traffic programme
function on or off.
The display “TP” in combination with a station name (e.g. in the station or preset list),
indicates a traffic programme station.
Irrespective of which radio station is heard, an additional receiver part in the unit
ensures that a traffic programme station can always be received as long as the traffic
programme function is switched on.
The functionality of the traffic programme function “TP” is displayed at the top right on
the touch-screen.
If no traffic programme station can be received because, for example, radio reception
is interrupted in general, “No TP” will be displayed instead of “TP”. Remember that car
parks, tunnels, high buildings or mountains can interrupt the radio signal up to the
total loss of reception.
Incoming traffic announcement
If you wish to interrupt the transmission of the traffic announcement, press on the
function key in the pop-up window Traffic announcement. The traffic
programme function remains available and a following traffic announcement is made
again while the audio mode is in operation. Pressing the function key
will switch off the traffic programme function permanently.
memory
1 ... 6 ...
RADIO
Extras
TP
Cancel
TP deactivated
s32k.a.book Page 17 Friday, September 18, 2009 1:54 PM
To Next Page
Loading...
Need help?
General
