General information 9
Climatronic
If your vehicle is equipped with climatronic, a feedback is received on the screen when
changing the settings.
Display of time
You can switch the display of the time on or off in the menu Setup System.
Switching the system on and off
– The system is switched on or off by pressing the control button .
The last active audio source before switching off is repeated.
If the key is pulled out of the ignition lock while the unit is switched on, the unit will
switch off automatically.
You can then switch the unit on again. If the ignition is switched off, the unit (discharge
protection of the vehicle battery) switches off automatically after approx. one hour.
This process can be repeated as often as necessary.
Anti-theft protection
The anti-theft coding of your navigation system prevents an operation of the system
after a voltage interruption, e.g. during a vehicle repair or after theft. After discon-
necting the battery, disconnecting the navigation system from the on-board voltage of
the vehicle and after a fuse failure, the code must be entered before the vehicle can be
used again.
Enter code
– If a keypad appears after switching on with the command to enter the code, the
unit can be unlocked by entering the correct four-digit code number. The number
of the possible attempts is shown in the second touch-screen line.
– Press a digit from to on the digit block displayed on the screen. The digit is
accepted in the entry line.
– After a four-digit order has been entered, the group of digits will turn grey (inactive)
and no further digits can be accepted in the entry line.
– Press on the touch-screen to erase the digits in the entry line from right to left
and thereby correct your input, if necessary.
– If the correct code number is displayed in the entry line, press .
Code number
The code number can only be called up “online” via the Škoda system, as this guaran-
tees even more effective anti-theft protection. Please contact your Škoda dealer if
necessary.
Incorrect code number
If an incorrect code is confirmed after entry of the code, the procedure can be repeated
once again. The number of possible attempts is shown in the second line on the
touch-screen.
If the code number is entered incorrectly for the second time, the unit will be blocked
for approx. one hour. It is possible to enter again the safety code after one hour has
expired, when the unit and the ignition have been switched on.
If two invalid attempts are then made again, the navigation system will be blocked
again for an hour.
The cycle - two attempts, blocked for an hour - will continue to apply.
Note
The code is normally stored in the instrument cluster. This ensures that it is automati-
cally decoded (convenience coding). Manual input of the code is normally not
necessary.
To Next Page
Loading...
Need help?
General
