Range selector key NAV (Navigation) 39
Select a point of interest as a travel destination
In the menu New dest., press on the function key . When in the menu POI search
you determine the options for the search of a point of interest.
Select a point of interest category
– If you are searching for a special type of destination, for example a hotel, press
and select a main category by pressing the respective key in the following
menu.
– After selecting a main category, a list of selectable point of interest categories will
open. Press to switch back to a main category after viewing a sub-category.
– Alternatively, press on the function key , to display all
selectable point of interest categories in alphabetic order in a list.
– This point of interest category is now displayed in the menu POI search. You can
find an overview of all selectable point of interest categories at the end of this
chapter.
Determine search area
– Press to determine the area to be searched for a point of interest.
Determine further search options
– If you are searching for a special destination, for example a hotel, and you know its
name or phone number, press the function key or .
Starting the search
– If you have completed your entries in the search mask, press on the function key
. A pop-up window will open and a point of interest, which corresponds to
the selected options, will be searched for within a surrounding area of maximum
200 kilometers.
– Press on the function key to cancel the search of the point of interest and
to display the search results.
– If you press on the function key the search will be terminated without a
display.
Select a point of interest from the search results
– If only one point of interest was found which corresponds to the pre-selected
options, the Information window POI will open.
– If several points of interest were found, they will first of all be displayed in a list. At
the top of the list you can find the points of interest closest to the entered search
area (distance and direction information refer to linear distance). If you press on
the display of a point of interest in the list, the Information window POI will open.
Information window - POI
– Here you will find further information, e.g. the exact address and phone number of
the selected point of interest.
– Press in the “Information window special destination” to start route guidance
to the displayed point of interest.
– Press the function key , to store the displayed point of interest.
– Press the function key or to display further points of interest from the list if
several points of interest were found.
– Press the function key , to display the current vehicle position and the selected
point of interest in the map display.
Search area options
You can call up the menu Select search area by pressing the function key
.
You can determine where to search for a point of interest by selecting the menu Please
select search area. If you call up the menu, the search area is set to the current location.
- If a travel destination is selected, you can select the surrounding
area of this travel destination as a search area for the point of interest.
- Limits the search for a point of interest to the surrounding area of the current
location (standard setting).
- Use the input masks to enter the city where you intend to search for a point
of interest in the surrounding area.
POI
Category
F
Categories (Alphabetical)
Search area
Name with Te l.
Search
Results
Cancel
OK
,
b
.
Please select search area
Near destination
Position
Near city
s32k.a.book Page 39 Friday, September 18, 2009 1:54 PM
To Next Page
Loading...
Need help?
General
