Range selector key NAV (Navigation)44
Note
During destination guidance, the travel and arrival time information always relates to
the arrival at the final travel destination. The estimated travel or arrival time at a stop-
over is not displayed.
Enter a stopover
If, in addition to the displayed travel destination, travel to the destination or several
destinations still has to be undertaken, proceed as follows. You can insert the addi-
tional destination behind the displayed travel destination as a new end point of the
tour.
– After selecting a travel destination, press on the function key in the main
menu Navigation. A pop-up window will open.
– If you press on , the menu Exactly or close to will open for
selecting a stopover. The background of the unit changes automatically to the tour
mode.
– Select a stopover as described ⇒ page 38.
– If you have confirmed the new destination, you will be asked to select an entry
behind which the new destination should be placed. You therefore determine the
order of the destinations. Press to close the message.
– The main menu Navigation will now be opened in the tour mode ⇒ page 43,
fig. 18.
– Press the function key to start the route guidance to the first stopover of the
displayed tour.
– Press the function key and then to add further destinations to
your tour ⇒ page 44, “Arrange a new tour in tour mode”.
Leave tour mode
Ensure that all stopovers are deleted before you finish with the tour mode. You can
store the displayed tour with all the stopovers before ending it by pressing
⇒ page 45.
– Press on the function key in the main menu Navigation and on
in the pop-up window, to end the tour mode.
–Confirm the message “Do you really want to leave tour mode?” by pressing the
function key .
– Only the travel destination previously determined as end point is displayed in the
main menu Navigation.
Arrange a new tour in tour mode
– In the main menu Navigation, press on the function key and then on
to change to the Tour mode.
– Press on the function key and then on to arrange a new tour.
– In the menu New Tour press on the function key behind the display of the
starting point or of an indicated destination.
– Press on in the pop-up window.
– Select the type of stopover or
– Select a destination as described ⇒ page 38.
– If you have confirmed the first destination, the menu New tour will open again.
Press the function key next to the destination behind which a further destina-
tion should be inserted.
– Press on in the pop-up window and choose another destination.
– Press if you wish to end the tour input. The travel destination of your tour and
the next stopover is displayed in the main menu Navigation.
– Press the function key to start route guidance to the first stopover of your
tour.
– Press the function key to permanently store the displayed tour under its
own name in the destination memory ⇒ page 45, “Save tour”.
In the menu New tour “New Tour” acts as a replacement for a name which you can allo-
cate for this tour when the tour is stored.
Extras
New stopover destination
OK
Start
Extras Tour mode
Memory
Extras
Leave tour mode
Leave
Extras
Tour mode
Extras New tour
H
Dest. entry
Exactly Close to
H
Dest. entry
y
Start
Memory
s32k.a.book Page 44 Friday, September 18, 2009 1:54 PM
To Next Page
Loading...
Need help?
General
