service
turn on
›
Push the lever in the
direction of the arrow.
Lights up in the instru-
ment cluster from
the isolation box.
Turn o
›
Manually switch the high beam on or o.
Function restriction
The system may dazzle other road users if their
headlights/lights are not detected for the following
reasons, for example.
▶
The headlights/lights of oncoming vehicles are
covered by crash barriers, for example.
▶
The headlamps/lights of the oncoming or preced-
ing vehicle are dirty or not functioning. The system
can also recognize a vehicle as a single-lane means
of transport.
Settings
Activation / deactivation
The Dynamic Light Assist is activated or deactivated
in Infotainment in the following menu.
Or:
Replace light bulbs
What you should be mindful of
DIY replacement of the following bulbs is possible.
Have the remaining light sources replaced by a spe-
cialist garage.
The new bulb must conform to the specification of
the original light bulb. The name of the bulb is
marked on the bulb socket.
NOTICE
Danger of headlight damage due to the ingress of
water and dirt!
▶
Always fit the protective cap on the headlight cor-
rectly after changing a bulb.
Conditions for changing a bulb
✓ Ignition switched o.
✓
Light switched o.
Front turn signal
›
Remove the protective cap from the headlight.
›
Remove the base with the bulb.
›
Change the bulb in the
socket.
›
Push the base with the
light bulb into the lamp
so that the fixing lugs
A fit into the recesses
on the headlight.
›
Reinstall the protective
cap on the headlight.
Rear turn signal and reversing lights
Loosen and remove the lamp
›
Remove the cover with
the bracket from the
tool kit.
›
Unscrew the screws
A and remove the
lamp.
›
Press the lock mecha-
nisms on the connec-
tor and remove the
connector.
52
Lighting, windscreen wipers and washers › Replace light bulbs
To Next Page
Loading...
