EasyManua.ls Logo

Skyjack Compact Rough Terrain Series - Page 69

Skyjack Compact Rough Terrain Series
264 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SKYJACK, Page 70
SJRT Compact Series
Engine Powered
TROUBLESHOOTING INFORMATION - ELECTRICAL SYSTEM
4.1-1. All Controls Inoperative
1. Battery disconnected or discharged.
- Reconnect battery. Recharge if discharged.
2. Loose or dirty battery cables.
- Clean and tighten battery cables.
3. Defective main fuse (F1) 300Amp.
- Check fuse. Replace if defective.
4. Open or defective main power disconnect switch (S1).
- Close switch. Replace if defective.
5. Loose or broken wire #03 from main power disconnect switch (S1) to circuit breaker (CB1).
- Check continuity. Replace if defective.
6. Tripped or defective circuit breaker (CB1).
- Reset breaker. Check for defective wiring. Replace breaker if defective.
7. Loose or broken wire #3A from breaker (CB1) to base terminal block (TB-1).
- Check continuity. Replace if defective.
8. Loose or broken wire #3A from base terminal block (TB-1) to base emergency stop switch (S6)
- Check continuity. Replace if defective.
9. Defective base emergency stop switch (S6).
- Check switch. Replace if defective.
10. Loose or broken wire #5 from base emergency stop switch (S6) to base terminal block (TB-1).
- Check continuity. Replace if defective.
11. Loose or broken wire #5 from base terminal block (TB-1) to emergency stop switch (S4).
- Check continuity. Replace if defective.
12. Defective emergency stop switch (S4).
- Check switch. Replace if defective.
13. Loose or broken wire #10 from emergency stop switch (S4) to base terminal block (TB-1).
- Check continuity. Replace if defective.
14. Loose or broken wire #10 from base terminal block (TB-1) to key switch (S10).
- Check continuity. Replace if defective.
15. Defective key switch (S10).
- Check switch. Replace if defective.
4.1-2. No Power To Platform
1. Open or defective key switch (S10).
- Check switch. Replace if defective.
2. Loose or broken wire #07 from key switch (S10) to base terminal block (TB-1).
- Check continuity. Replace if defective.
3. Loose or broken wire #07 from base terminal block (TB-1) to emergency stop switch (S4).
- Check continuity. Replace if defective.
4. Open or defective platform emergency stop switch (S4).
- Check switch. Replace if defective.
4.1-3. All Functions Inoperative From The Platform
1. Open or defective emergency stop switch (S4).
- Check switch. Replace if defective.
2. Loose or broken wire #08 from emergency stop switch (S4) to base terminal block (TB-1).
- Check continuity. Replace if defective.
Go to Discount-Equipment.com to order your parts

Table of Contents

Related product manuals